FRONT PANEL
AV1 INPUT - VIDEO -
Audio /Video Input Jacks (Video1)
Connect external video equipment here
(see page 9).
REAR PANEL
AV2 INPUT
R
AUDIO
L
S-VIDEO
(MONO)
VIDEO
S-Video Input Terminal
To enhance video detail use the S-Video jack instead of the Video jack, if available
on your external equipment. (S-Video connection will override a connection to the
rear Video jack.)
REMOTE CONTROL
INSTALLING BATTERIES (2 AA not included)
1. Remove the battery cover by pressing the tab and tilting the cover
upward. Insert batteries. Make sure you match
signs on the batteries with marks inside the remote control.
2. Replace battery cover. The remote control is ready!
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
MENU
L-AUDIO-R
UHF / VHF / CATV
75Ω
Audio/Video Input Jacks (Video2)
Connect external video equipment
here (see page 10).
VOL
CH
CH
Lift up here to open
Cable / Antenna Input
Terminal (75 ohms)
+
/
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
See pages 9~10 before
connecting external
video
equipment.
Cables are not
supplied for connect-
ing your external
-
+
equipment.
A solid Blue screen
with the word Video1
or Video2 displayed
means that the
Video/Game mode is
selected, but no signal
is being detected at the
Video jack. Check con-
nection, and turn on
external equipment.
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want to
operate. Objects
between the remote
control and the equip-
ment may cause
misoperation of the
remote control
function.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
IMPORTANT NOTE: Spent or dis-
charged batteries must be recycled
or disposed of properly in compli-
ance with all applicable laws. For
detailed information, contact your
local County Solid Waste Authority.
5