Sanyo AVM-2760S Manuel D'instructions page 6

QuickTips
Point the remote
control toward the
equipment you want to
operate. Objects
between the remote
and the equipment
may cause misopera-
tion of the remote
control function.
Make sure batteries
have been installed
correctly.
If the remote control
does not work: Press
TV key (see item 1).
The remote control
must be programmed
before it will operate
your VCR or Cable
Box. See page 7.
Cannot select channel
with number keys.
Press "0" in front of
numbers 1 ~ 9.
Example: Channel 05.
The "C" in front of the
channel number indi-
cates a Cable channel.
Adjusting the volume
level: Right flashing
arrow indicates
volume is increasing
and left flashing arrow
indicates volume is
decreasing.
Channel number will
not display continuously
when captioning is on.
Using V-Guide
TV Parental Guide-
lines settings can be
changed only by using
the Remote Control.
See pages 12 and 13.
6
UNIVERSAL REMOTE CONTROL KEYS
Point towards TV
VCR TV
VIDEO
POWER
MODE
1 2
4 5
7 8
CAPTION
0
MENU
VOL
CH
MUTE
PLAY
REC STOP
V-GUIDE
Mode Keys
Use these keys to program the remote
control and to select the operating
mode (VCR, TV, or Cable).
Video Mode Key
Press to select the program source to
be displayed on the screen: TV signal
or signal from the equipment you have
connected to the A/ V jacks.
Number Keys
Two keys must be pressed to select a
channel. Example: Press 0 then 6 to
select channel 6. For cable channels
100 through 125, press and hold the
1 key until C C C C 1 1 – – – –
1 1 – – – – appears. Then press
the other two numbers.
Caption Key (See page 11.)
CABLE
RESET
3
11
6
9
SLEEP
12
RECALL
13
VOL
DISPLAY
14
PAUSE
11
12
13
14
Menu Key
Use this key with the
/ keys to navigate and adjust
features of the on-screen menu system
(see pages 8 and 9).
Channel (CH) Scanning (
and Volume ( / ) Keys
Press to scan through the channels in
memory and to adjust the volume.
Mute Key
Press once to turn off the volume.
Press again to restore.
Note: When using the audio out jacks
this key will not mute the sound.
VCR Keys
These keys control the VCR's Fast
Forward ( ), Rewind (
Play ( ), Record (
Stop ( ), and Pause (
functions.
V-Guide Key (See pages 12 and 13.)
Reset Key
Press this key twice to restore factory
settings. The TV will automatically
start Channel Search and clear all
customized settings. (See page 14.)
Power Key
Press to turn TV on or off.
Sleep Key
Use this key with the "0" key to set the
Sleep Timer (see page 14).
Recall Key
Select a channel then select another
channel using the number keys. Press
Recall to switch between the channels.
Display Key
Press once to display the channel
number and time. Press twice to
display the channel number continu-
ously. Press again to remove the
display.
/ and
/ )
),
),
)