Installation Notes & Maintenance - Pentair PENTEK PSD25PB Manuel D'installation Et D'utilisation

Solaire disque
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation Notes:
Date Installed: ___________________________________________________________________
Serial No. (Spec Label): ___________________________________________________________
Installer: ________________________________________________________________________
Phone: __________________________________________________________________________
Location of Installation: __________________________________________________________
Pump Model No: _________________________________________________________________
Motor: HP, Vac, Ph, SF Amps: ______________________________________________________
Static Depth (m/ft):_______________________________________________________________
Flow Rate (lpd/gpd): ______________________________________________________________
AC Source Voltage Level: _________________________________________________________
PV Panel Manufacturer/Model Number: ____________________________________________
No. of Solar PV Panels in Series: ___________________________________________________
Note to Installer: We strongly recommend that the installation notes above are filled out
with valid data and that the manual remains accessible and located close to the unit. Also,
if you are calling our technical support, please have this installation data available for a
faster and more accurate troubleshooting process.
Maintenance:
The Pentair Pentek* Solar Drive is designed to operate autonomously, however it is
suggested to be inspected every 3 months. If there are any external obstructions that
prevent proper cooling of the heat sink, please remove them to make sure nothing blocks
the air flow from the bottom of the device.
If the Pentair Pentek Solar Drive operates in the area where the pump experiences freezing
temperatures, make sure to turn OFF the device so it does not try to run the water pump in
icy conditions. This may lead to dead heading on the pump.
Check external sensors every 3 months: float switch, pressure switch, etc.
16
P1063 (10-03-19)

Publicité

Chapitres

Table des Matières
loading

Table des Matières