Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Pentair Pentek
Once the system is wired (per Figure 8), the power conductors wired to the DIN rail
terminals inside the Pentair Pentek Solar Drive should be tightened with torque values of:
– Solar PV and motor load conductors: 10 lb-in
– AC source conductors: 10 lb-in
The cable glands (cord grips) on the bottom of the enclosure should be used as follows:
– 1/2 inch cord grips should only be used with a cord that is 0.280-0.455 inch
outer diameter.
– 3/4 inch cord grips should only be used with a cord that is 0.455-0.705 inch
outer diameter.
When all conductors are wired into the controller, the cover (enclosure door) should be
replaced and tightened using the cover screws to 2-3 in-lb or equivalent.
Terminal 1
(Yellow)
Terminal Aux
(Grey)
Yellow
Red
Black
Red
Float Switch/
Other Sensors
Single phase motor loads should be wired as shown in Figure 8. 3-wire motors should be wired
so that Common Lead is wired to Phase A, Starting Winding to Phase B and Main Winding to
Phase C. Use DIP Switch 8 for proper single phase motor selection.
IMPORTANT:
Three Phase Motor
Terminal 1 (Yellow): YELLOW wire
Terminal 2(Red): RED wire
Terminal 3(Black): BLACK wire
10
Solar Drive Wiring Instructions
*
3-Wire,
Single
Phase
Motor
Figure 8: Wiring Inside the Pentair Pentek Solar Drive
AC Source
Three
Solar PV
Phase
Motor
Single Phase 3-wire Motor
Terminal 1(Yellow): YELLOW wire – common motor lead
Terminal Aux(
): RED wire – start motor lead
Grey
Terminal 3(Black): BLACK wire – main motor lead
Terminal 2
(Red)
Terminal 3
(Black)
Red
Black
Red
Black
System
Ground
P1063 (10-03-19)
Publicité
Chapitres
Table des Matières
