Hoover WH21000 Guide D'utilisation page 9

WARNING:
Never leave the Steam
Cleaner in one spot on any surface for an
extended period of time with a damp or wet
Microfiber pad attached as this may damage
the floor surface When cleaning hard floors,
your Steam Cleaner should only be used on
tiles, linoleum, sealed hardwood flooring,
laminate, vinyl and sealed stone floors If
used on waxed flooring, you may experience
loss of glossiness To reduce the risk of
personal injury, unplug the steam cleaner
when assembling the accessories Do not
clean over floor electrical outlets Do not use
steam cleaner or press the Steam Trigger
without water in the Main Water Tank
WARNING:
Do not clean over floor
electrical outlets Do not use steam cleaner
or press the Steam Trigger without water in
the Main Water Tank
IMPORTANT:
When using on carpets,
always ensure the multi-surface Microfiber
Pad is properly attached to the Floor Head
Operation
5. 6.
To recline the steam To produce steam
cleaner place foot squeeze the trigger in
here and pull handle short bursts. Don't hold
backwards. the trigger continuously
to prevent over saturating
floors.
TO SANITIZE HARD SURFACES
Wait for the green light to illuminate to show steam is ready (60 seconds).
Turn the steam control dial to "MAX" position. Connect the microfiber pad and run a minimum of 6
strokes at a medium pace (5-7 seconds per 32" stroke) across same area. Allow to dry.
• Always switch off the steam cleaner before
emptying the water tanks or changing the cleaning
pads/accessories.
7.
Move the steam cleaner
slowly backwards and
forwards across the floor.
Squeeze and release
trigger as required.
• Don't aim the steam cleaner at people, animals, plants
or electrical components such as interior of ovens or
wires. Never touch the steam spray or floor head from
a short distance. (There is a risk of scalding)
9