Auto Operation - Toshiba RBC-IR1-PE Mode D'emploi

All manuals and user guides at all-guides.com
I R
NFRARED
A
UTO
5,6
1
ON
OFF
MODE
M O D E
AUTO
4
TEMP.
TEMP.
°C
24
FAN
3
F A N
AUTO
2
A U T O
TIMER
S E T
CLOCK
ON OFF
TIME ADJUST
RSV CNL
LOCK
1. Remote Controller
Select the operating mode.
Press the MODE SELECT button and set the
display to AUTO.
2. CHR/KHR/PGR only
To drive the outlet louvers automatically, press
this button.
3.
To select the indoor fan speed. Press the FAN
SELECT button and set the display to the
desired speed (AUTO, LOW, MED or HIGH).
At the AUTO position, the speed is changed
automatically with the room temperature.
4.
Set the desired temperature.
Press the buttons to set the
temperature as desired.
5.
Press the ON/OFF button.
The ON/OFF lamp (red) will now light.
With the indoor fan stopped, the preheating
operation lasts for between 3 and 5 minutes.
Warm air is then blown out.
GB
C
EMOTE ONTROLLER
O
PERATION
5
OPERATION
DEFROST
TIMER
REMOTE-CONTROL
COOL AUTO
MANUAL-CONTROL
6.
OFF
Press the ON/OFF button again.
The lamp goes off and operation will stop.
If the operation is stopped and then the ON/
OFF button is pressed immediately, the air
conditioner will not operate for about 3
minutes, to protect the unit.
After about 3 minutes, operation will be
restarted automatically.
For details on how to use the timer, see pages
12, 13.
Note: The air conditioner system should be
switched on at the main switch.
The air conditioner should not be turned OFF
except for servicing.
At initial power on RED lamp on indoor unit
receiver will flash.
Press ON/OFF button to turn on.
– 9 –