How To Start Group Operation - Toshiba TCB-SC642TLE Manuel Du Propriétaire

How to start group operation

To start group operation
2
1
9
8
Power Turn the power supply switch on more than 12 hours before starting operation.
1 Press the SELECT button and select GROUP.
2 Select the ZONE No. including the group to be operated by pressing ZONE button.
3 Select the GROUP No. to be operated by pressing GROUP select buttons
4 Set the operation mode by pressing the MODE button.
5 Press the ON button.
6 Set the desired temperature by pressing one of the temperature setting buttons
7 Set the desired fan speed by pressing the FAN SPEED button.
8 Set the airflow direction to a specific angle or sweep mode.
9 By pressing
Individual: → Controls with the remote controller are possible.
Central 1: → Individual ON/OFF operation with the remote controller is inhibited.
Central 2: → Individual ON/OFF, MODE, and Temp. setting operations with the remote
Central 3: → Individual MODE and Temp. setting operations with the remote controller are
Central 4: → Individual MODE operation with the remote controller is inhibited.
• Under Central/Individual settings other than listed above, "CENTRAL" is displayed.
AUTO Depending on the difference between the temperature setting and the room temperature,
Operation heating and cooling alternate automatically so that a uniform room temperature is maintained.
Some models are not provided with a mode for automatically setting the cooling or heating
operation.
Stop Confirming the GROUP No. to be selected, press the OFF button.
NOTE
8
, select your desired setting.
controller are inhibited.
inhibited.
The flap setting can be performed only for units that have no remote controllers.
5
Stop
3
4
6
7
.
.
OI-673-08EG