Publicité
Les langues disponibles
Les langues disponibles
5.3
Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4
Fitting/changing the abrasive belt
CAUTION
Risk of injury! The abrasive belt can easily tear if the direction of travel is incorrect.
▶ Be sure to install the abrasive belt right way round for the direction of travel. The belt's direction of travel
must match the direction-of-travel arrow on the gear head.
1. Push the swing arm back toward the drive roller and hold it in this position.
2. If applicable, remove the abrasive belt.
3. Loop the new abrasive belt over the rollers.
4. Release the swing arm.
5. Check that the abrasive belt is fully seated on the rollers.
5.5
Fitting the side handle
1. Screw the side handle into the threaded socket.
2. The side handle can be screwed into the threaded socket on either side. Consequently, very awkward
places can be reached.
6
Operation
6.1
Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
➥ The motor runs.
3. Lock the on/off switch.
6.2
Setting belt speed
▶ Use the adjusting knob to set the belt speed.
6.2.1
Belt speed without load
Stage 1
Stage 2
Stage 3
Stage 4
Stage 5
Stage 6
6.3
Grinding
4
CAUTION
Risk of injury! Touching a moving abrasive belt can lead to painful skin abrasion and cut injuries.
▶ Do not touch the moving abrasive belt.
*2241360*
2
3
2241360
3.8 m/s
(12.5 ft/s)
4.3 m/s
(14.1 ft/s)
4.9 m/s
(16.1 ft/s)
5.9 m/s
(19.4 ft/s)
7.2 m/s
(23.6 ft/s)
8.4 m/s
(27.6 ft/s)
English
7
Publicité
