Emerson 4th AVENUE CF766LBQ00 Mode D'emploi page 17

6.7
Pass the Wire Connectors and Wires through the center
hole of the Lower Housing.
Install the LED Light Fixture Assembly onto the Lower
Housing by aligning and engaging the keyhole slots of
the LED Light Fixture Assembly with the loosened
screw heads on the Lower Housing (Figure 28).
Rotate the LED Light Fixture Assembly clockwise to
engage the two loosened screws.
With the LED Light Fixture Assembly locked into the
keyhole slots, tighten the two previously loosened
Screws.
Reinstall the #8-32 x 3/8" Pan Head Screw (previously
removed) into the LED Light Fixture Assembly
(Figure 28).
A spare #8-32 x 3/8" Pan Head Screw is provided in
parts bag, if needed.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the Lower Housing and the LED Light Fixture
Assembly.
6.8
Place the Glass into the opening of the Lower Housing,
aligning the three Flat Areas on the top edge of the
Glass with the three raised Dimples on the Lower
Housing and turn the Glass clockwise until it stops
(Figure 29).
NOTE: Periodically check that the Glass is seated
fully clockwise in the Lower Housing.
6. Final Assembly
(Continued)
LOWER HOUSING
LED LIGHT FIXTURE
ASSEMBLY
REINSTALL ONE #8-32 x 3/8"
PAN HEAD SCREW
TIGHTEN THE #8-32 x 3/8"
PAN HEAD SCREWS
Figure 28
DIMPLES (3)
LED LIGHT FIXTURE
ASSEMBLY
FLAT AREAS (3)
GLASS
Figure 29
17
Please contact 1-800-654-3545 for further assistance
ROTATE
CLOCKWISE
ROTATE
CLOCKWISE
emersonfans.com
ETL Model No.: CF766L