Read I/M Readiness Status Data - BGS technic 6648 Mode D'emploi

Lecteur de code de panne obd ii eobd
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.5 Read I/M Readiness Status Data

I/M Readiness option allows to view a snapshot of the operations for the emission system on
OBDII/EOBD vehicles. I/M Readiness is a useful function used to check if all monitors are OK or N/A.
The vehicle's computer performs tests on the emission system during normal driving conditions. After
a specific amount of drive time (each monitor has specific driving conditions and time required), the
computer's monitors decide if the vehicles emission system is working correctly.
When the monitor's status is:
OK - vehicle was driven enough to complete the monitor.
INC (Incomplete) - vehicle was not driven enough to complete the monitor.
N/A (Not Applicable) - vehicle does not support that monitor.
There are two types of I/M Readiness tests:
Since DTCs Cleared - shows status of the monitors since the DTCs were last cleared.
This Drive Cycle - shows status of monitors since the start of the current drive cycle.
Below is a list of abbreviations and names of OBD II monitors supported by the code reader.
No.
1
Misfire Monitor
2
Fuel System Mon
3
Comp. Component
4
Catalyst Mon
5
Htd Catalyst
6
Evap System Mon
7
Sec Air System
8
A/C Refrig Mon
9
Oxygen Sens Mon
10
Oxygen Sens Htr
11
EGR System Mon
There are two ways to retrieve I/M Readiness Status data:
One-click I/M readiness key
Typical way: select I/M Readiness from Diagnostic Menu
NOTE
To review I/M Readiness status, make sure that the ignition key is switched to ON with the engine
off.
Not all monitors are supported by all vehicles.
To retrieve I/M Readiness Status data by one-click I/M readiness key:
1. Press the One-Click I/M Readiness Key on the keypad and the following screen displays.
2. Colored LED and build-in beeper provide both visual and audible reminders for emission check
and DTCs. Below is the interpretation of the LED and build-in beeper.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Abbreviation
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
9
Name
Misfire Monitor
Fuel System Monitor
Comprehensive Components Monitor
Catalyst Monitor
Heated Catalyst Monitor
Evaporative System Monitor
Secondary Air System Monitor
Air Conditioning Refrigerant Monitor
Oxygen Sensor Monitor
Oxygen Sensor Heater Monitor
Exhaust Gas Recirculation System Monitor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed

Publicité

Table des Matières
loading

Table des Matières