BGS technic 6648 Mode D'emploi page 27

4.1 Read Codes
Read Codes menu lets you read stored codes, pending codes and permanent does found in the
control unit. Typical menu options include:
•
Stored Codes
•
Pending Codes
•
Permanent Codes
To read codes from a vehicle:
1. Press the Read hot key to directly read the codes from home screen. Or scroll with theUP/DOWN
key to highlight Read Codes from Diagnostic Menu and press the OK key.
2. Select Stored Codes/Pending Codes/ Permanent Codes and press the OK key to confirm.
3. A code list including code number and its description displays.
4.2 Erase Codes
There are two ways to erase codes:
•
Press the Erase hot key to erase codes from home screen.
•
Traditional way: select Erase Codes from the diagnostic menu.
1. Press the Erase hot key to directly erase the codes from the home menu. Or use the UP/DOWN
key to highlight Erase Codes from Diagnostic Menu and press the OK key.
2. Follow the on-screen instructions and answer questions about the vehicle being tested to
complete the procedure.
3. Check the codes again. If any codes remain, repeat the Erase Codes steps.
4.3 Live Data
Live Data menu lets you view, record and playback real time PID data from the electronic control
module.
Menu options typically include:
•
View Data
•
Record Data
•
Playback Data
4.3.1 View Data
The View Data function allows real time viewing of the vehicle's electronic control unit's PID data,
including sensor data, operation of switches, solenoids and relays.
Menu options typically include:
•
Complete Data
•
Custom Data
•
Unit of measure (Please refer to Chapter 7 System Setup)
4.3.1.1 Complete Data Set
Complete Data Set displays all supported PIDs of the vehicle being tested.
To view all live PID data:
1. Use the UP/DOWN key to highlight Live Data from Diagnostic Menu and press the OK key.
2. Select View Data or Complete Data Set from the list and press OK key to confirm.
3. Press the OK key to view PID graph if the PID gives a numeric reading.
4.3.1.2 Custom Data List
Custom Data List menu lets you to minimize the number of PIDs on the data list and focus on any
suspicious or symptom-specific data parameters.
To create a custom data list:
1. Select Custom List from the menu and press the OK key.
2. Use the RIGHT key to select or deselect a line or press LEFT key to deselect all if needed. Press
the OK key to confirm and ESC key to cancel.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
7
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed