Fitting The Light In The Wall Crossing; Fitting The Light In The Brio Recess (Pf10R261 Or Pf10R262); Monochromatic Lights: Dimming / Luminous Intensity Variation (Only Pk10R400-401); Rgb & Rgbw Lights: Use - Autonomous Mode (Only Pk10R402-406) - ccei Mid-BRiO Notice Technique

Technical information sheet

4.2. Fitting the light in the wall crossing

1. Fit the trim purchased separately onto the Mid BRIO using the 4 notches on the front of the light
2. Position the light in the axis of the discharge nozzle and screw it in until the trim is against the wall.

4.3. Fitting the light in the BRiO recess (PF10R261 or PF10R262)

1. Fit the supplied trim onto the Mid BRiO using the 4 notches on the front of the light
2. Position the light in the BRiO recess (after connection and tightening of the cable gland at the back of the recess, see
instructions supplied with the recess)
3. Make a quarter turn once the light is in place to fix it to the BRiO recess
5. Monochromatic lights: dimming / luminous intensity variation (Only
PK10R400-401)
You have the possibility to manage the luminous intensity of your lights with micro-power cuts (<1s). 3 levels are available :
• 1 micro-cut = 100% of power
• 2 micro-cuts = 75% of power
• 3 micro-cuts = 50% of power
• 1 micro-cut = Back to 100%
When the projector is re-powered after being switched off for more than 5 seconds, it switches back on at the last selected
power level.
6. RGB & RGBW lights: Use - Autonomous mode (Only
PK10R402-406)
In the absence of a control unit, the bulbs operate autonomously and the user can choose between 18 modes: 11 colour sets
and 7 programs (with shorts cutting power supply).
Change of mode and reset
• A small cut of power supply (less than 1s) switches to the next colour / sequence. Once all the colours are displayed, the
light goes back to the first colour (pure white).
• A cut of supply (2s) resets the light synchronization and switches them to the second colours (blue)
• After a long stop (more than 4s) the light show the last displayed colour.
Fixed colours and available sequences
The colours and sequences are displayed in a preassigned order:
• 1 to 11 : fixed colours. 1.Pure white | 2.Blue | 3.Blue Lagoon |4.Cyan | 5.Violet | 6.Magenta | 7.Pink | 8.Red | 9.Orange |
10.Green | 11.Warm white
Mid-BRiO & Mid-BRiO LT M24 & X24
A. Bend at the back of the cross part not watertight (see wall
crossing installation)
B. Raise the electric connection above the water level (in this
case in a junction box)
v1.0EN
3