Packaging Contents; Installation; Installation In The Wall Conduit; Electrical Connection - ccei Mini Brio M12 Notice Technique

Technical Manual

2. Packaging Contents

1 BRIO light Mini Brio M with
• 2x0.75mm² cable: 3m (pre-assembled)
• Technical manual (this document)

3. Installation

To ensure good fixing the engraved arrow under the patch (at the glue side) should point inside the pool

3.1. Installation in the wall conduit

Threaded wall conduit 1.5''
1. Pass the cable through the wall con-
duit
2. Push and screw it thoroughly

3.2. Electrical connection

Installation of this product involves a hazard of electric shocks. We strongly recommend you
contract a professional installer. Incorrect installation places you in danger and may irre-
versibly damage the product and the equipment connected to it. In compliance with the NF C
15-100 standard, pool lights installed in Volume 0 must always be powered with SELV (Safety
Extra Low Voltage). Always cut off the power upstream before handling the electrical instal-
lation.
Risk of electric shock. Only connect to a circuit which is protected by a ground-fault circuit
interrupter. If you are not sure if these types of devices are fitted, contact a qualified electrician.
Mini Brio M12 (&12K, 12B) & 12HW
A. Bend of the back of the non-watertight wall conduit (refer
to the installation of the wall conduit)
B. Raise the cable above the water line (here in a connection
box)
Threaded wall conduit 2''
1. Screw the cable into the adaptor and
pass the cable through the wall con-
duit
2. Push and screw it thoroughly
Non-threaded wall conduit 2''
1. Place the o-ring provided with the
adaptor
2. Pass the light cable through the wall
conduit
3. Push the light to the stop
v2.0ML
2