Installation In Ccei Return Fitting; Operation - Standalone Mode (Pk10R402 And Pk10R406 Only) - ccei Brio Notice Technique

Technical instructions

4.3. Installation in CCEI return fitting

When you install a Brio with a CCEI return fitting (see images below), you can mount the O-ring
between the Brio and the return fitting (use grease during installation). Once you tighten thefixture,
the O'ring allows for a dry casing between the rear of the fixture and the connection box above the
water level.
This increases the watertightness of the connection box and reduces the risk of freezing in the shaft.This
seal alone cannot guarantee the watertightness of the swimming pool but provides better protection for
the junction box. If the fixture is unscrewed when the water level is above it, the shaft will instanty
fill with water.
Return fitting for concrete pool or liner pool (PF
10R291 / PF10R292)
5. Operation - Standalone Mode (PK10R402 and
PK10R406 only)
In the absence of a control box, the Brio operates autonomously and the user can choose between 18
modes: 11 fixed colors and 7 programs with micro power cuts.
Mode change and reset
• A power failure of <1s allows you to switch to the next color / sequence. Once every color appears,
the lighting returns to the first color (pure white).
• Two cuts under 1 second resets the lights synchronization and switches them all to the second colors
(blue)
• Restarting after a long outage (>4s) turns the lights back on to the last color selected.
Fixed colors and available sequences
The colors and sequences are displayed in a preassigned order:
• 1 to 11: fixed colors. 1. Pure white | 2. Blue | 3. Blue Lagoon | 4. Cyan | 5. Purple | 6. Magenta | 7.
Pink | 8. Red | 9. Orange | 10. Green | 11. Sea green
• 12 to 18 : sequences. 12..Fast gradient | 13..Slow rainbow | 14..Colors parade | 15.Techno rhythm |
16.Blue variations | 17.Random parade | 18. Random colors
Brio White and Color
1. Set the O-ring in wall through and pass the ca-
ble through the return fitting.
2. Set the O-ring around the rear part of the light.
3. Push and screw it thoroughly until the flange
is in contact with the wall of the pool.
v1.0CAEN
ccei.ca
5