Remote Control Programming - Leggett & Platt S-cape 2.0 Manuel Du Propriétaire

Program One Remote to Operate One Base - Bases
are factory programmed to operate as one remote
control to one base. If reprogramming is required,
perform the following numbered procedure. If
programming fails, initiate the programming
procedure a second time.
SteP 1
UNPLUG the base from the electriclal power source
(if plugged in). Wait 3 minutes.
SteP 2
Plug the base into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 3
Simultaneously press and hold the head up and foot
up buttons on the remote control until the backlight
flashes. Release both buttons.
Press the head up or foot up button on the remote
control to verify base functions.
One remote control is now programmed to operate
one base.
10
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®

remote coNtrol ProGrammiNG

Program One Remote to Operate Two Bases - Bases
are factory programmed to operate individual
bases. To program one remote to operate both
bases, perform the following numbered procedure.
If programming fails, initiate the programming
procedure a second time.
SteP 1
UNPLUG both bases from the electriclal power
source (if plugged in). Wait 3 minutes.
SteP 2
Plug base 1 into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 3
Simultaneously press and hold the head up and foot
up buttons on the remote control until the backlight
flashes. Release both buttons.
SteP 4
Plug base 2 into the electrical power source.
You now have 3 minutes to complete the
programming procedure.
SteP 5
Simultaneously press and hold the head up and foot
up buttons on the remote control until the backlight
flashes. Release both buttons.
Press the head up or foot up button on the remote
control to verify both bases function.
One remote control is now programmed to operate
two bases.
Note: The second remote is not needed. Store it for
use as a spare.
BASE 1
BASE 2