Télécharger Imprimer la page

Husky 33120 Instructions D'assemblage page 7

Kit de service de support de cadre

Publicité

Les langues disponibles

Les langues disponibles

8. Once the spring bar is resting securely on the lift bracket insert the "L" retaining pin into the
square hole and secure with the hair pin clip.
WARNING: Keep clear of the pivot path of all moving parts when there is tension on the spring
bar. Maintain control of the lift handle at all times when raising or lowering the spring bar. Be sure
that the "L" pin and hair pin is in place before driving.
9. Retract the tongue jack completely so the hitch is supporting the weight of the trailer. Measure
the same 3 places as done on pages 5 & 6 and compare. The tow vehicle should settle evenly
front to back. The rear fender should not settle lower than the front fender, if it has then you will
need to either raise the lift brackets 1 hole or add a hardened washer under the large head tilt
pin on the head assembly. The frame mark should be ¼"-1" max higher than the original
measurement noted on page 5, section 3.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /
Product Updates. 2021 Keystone Automotive Operations Inc. All Rights Reserved. 07/27/2021-Rev1
Check Vehicle Height and Adjust
Spring Bars If Necessary
Page-7

Publicité

loading