Publicité
Les langues disponibles
Les langues disponibles
heater assemBly
Note: If needed, acquire assistance lifting assembly.
1. Place entire lightpost assembly on top of cabinet base assembly.
Attach with 4 screws (H).
Install 2 screws (H) into holes on each side of control valve. Attach
control valve nut and control knob to control valve.
6
2. Connect 2 brown wires to ON/OFF switch.
3. Connect white ground wire attached to cabinet to right post on
electronic ignitor. Remove wire tie. Connect black ignitor wire to
left post on electronic ignitor.
4. Install batteries in battery holder. Do not mix batteries.
www.desatech.com
122789-01A
Publicité
