Publicité
Les langues disponibles
Les langues disponibles
5. Place pilot assembly on top of lightpost top with open section
facing back of burner assembly. Attach with 4 screws (H). Check
wire connections before proceeding.
6. Locate 2 deco light shrouds and 4 light shroud screens.
Attach 4 light shroud screens to light shrouds with 4 screws (F)
and 4 nuts (G) each. Only 2 of the 4 screens are shown.
122789-01A
7. Place deco light shrouds on top of lightpost top. Make sure flanges
are on top.
Slide shroud tabs together. Attach to lightpost top with 4 screws (H)
through holes in bottom of shroud pieces. Tighten all screws.
8. Attach lightpost top cap to shroud assembly with 4 screws (H).
www.desatech.com
5
Publicité
