Starmix GS 2450 Oil & Metal Notice D'utilisation page 19

ATTENTION - Duty cycle:
AC units are suitable for periodic operation.
After a prolonged period of operation of more than 90 minutes, a cooling phase of at least 30
minutes should follow.
Position the vacuum cleaner near the area to be cleaned and activate the wheel lock.
The model has 2 combination ON/OFF switches. The motors can be switched on and off separately.
Please note, the suction hose must be properly cleared before switching off or it may emit dangerous
substances after the device has been switched off.
The vacuum cleaner is now ready for use and shavings and liquids can be vacuumed.
The vacuumed shavings are collected – depending on the design – either in the shavings basket or on the
inserted shavings separation tray, which is located in the dust container. The liquids drip down into the lower
part of the dust container.
ATTENTION
If the liquid reaches the maximum fill level (see maximum arrow), the vacuum cleaner must be
switched off and the dirt container emptied.
ATTENTION
The viscous slime produced on cooling lubricants by microbacterial contamination should be disposed
of from the container separately. This is because the viscosity of this slime can seal the openings of
the shavings tray and prevent the passage or dripping of other liquids
Disposing of vacuumed material
Emptying the dust container:
1. Vacuuming out the suction hose
2. Press the OFF switch to switch off the vacuum cleaner.
3. The liquid can be drained via the drain hose.
4. Lower the dust container with the hand lever.
5. The shavings can now be disposed of separately. To do this, tilt out the dust container.
Model variant
1)
en
19