Briteq LDP-POWERBAR 6TC Mode D'emploi page 7

ENGLISH
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified technician!
SPECIFICATIONS OF THE LED POWERBAR 12 TC
Mains Input: AC 100-240V, 50/60Hz
Power consumption: 39 Watt
Fuse: 250V 6.3A slow blow (20mm glass)
DMX connections: 3pin XLR male / female
DMX channels used: 3/4/5/6 channels (depending on the DMX mode)
Lamp: 12 x 3in1 LED
Size: 1238 x 140 x 79 cm
Weight: 4.8kg
BRITEQ
®
OPERATION MANUAL
LDP-POWERBAR 6/12TC
ENGLISH
SPECIFICATIONS OF THE LED POWERBAR 6 TC
Mains Input: AC 100-240V, 50/60Hz
Power consumption: 21.6 Watt
Fuse: 250V 6.3A slow blow (20mm glass)
DMX connections: 3pin XLR male / female
DMX channels used: 3/4/5/6 channels (depending on the DMX mode)
Lamp: 6 x 3in1 LED
Size: 638 x 140 x 79 cm
Weight: 2.7kg
The information might be modified without prior notice
You can download the latest version of this user manual on our website:
BRITEQ
®
OPERATION MANUAL
www.beglec.com
LDP-POWERBAR 6/12TC