Lens Shift Function - JVC D-ILA DLA-QX1G Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing the Projector (Cont.)

Lens Shift Function

Some of the separately sold lenses have a lens shift function.
For the lens with the lens shift function: When the lens shift is set to 50%, install the projector so that the bottom edge of
the projection screen is at the same height as the center of the lens. When the lens shift is set to –50%, install the projector so
that the top edge of the projection screen is at the same height as the center of the lens .
For the lens without the lens shift function or when the lens shift is set to 0%: Install the projector so that the center of the
projection screen is at the same height as the center of the lens.
90°
90°
90°
• When using the lens with the shift function, you can adjust the projected image vertically using the setting menu or the SHIFT
+/– buttons on the remote control unit.
• When using the projectors in stack configuration (stacked one over another), make adjustment so that the picture of each
projector overlaps exactly using the lens shift function. If the horizontal adjustment is needed, consult your dealer.
• For detailed adjustment procedures, refer to pages 38 and 46.
• For maximum amount of shift, refer to "Maximum amount of shift" on page 23. (When the lens needs to be adjusted in
horizontal angles, consult your dealer.)
22
90°
90°
Center line of the lens
Center line of the lens
90°
90°
90°
90°
Center line of the lens
For the lenses with the lens shift function
When the lens shift is set to 50%
RGB Analog VIC
R
G
B
Y
H/C
S
When the lens shift is set to –50%
RGB Analog VIC
R
G
B
Y
H/C
S
For the lenses without the lens shift function
or when the lens shift is set to 0%
RGB Analog VIC
R
G
B
Y
H/C
S

Publicité

Chapitres

Table des Matières
loading

Table des Matières