Control Panel - JVC D-ILA DLA-QX1G Manuel D'instructions

Controls and Features (cont.)

Control Panel

9 p
1
OPERATE indicator
ON: When the projector is in operation (projecting)
OPERATE button
Press this button for one or more seconds while the
projector is in stand-by mode, the MAIN POWER switch is
turned on and the OPERATE indicator lights up.
Press it again, and the projector goes into the cool-down
mode, then stand-by mode.
For details on the operations, refer to pages 32 and 33.
Memo
While in the first 20 seconds of cool-down mode:
If you press the OPERATE button, the projector is not tuned on.
2
HIDE button
Use this button to turn off the image on the screen
temporarily. Pressing it again resumes the image.
For details on the operations, refer to page 36.
3
KEYSTONE buttons
Use these buttons to correct a trapezoidal distortion of the
projected image.
For details on the operations, refer to page 37.
4
VIC SELECT 1, 2, and 3 buttons
You can select the desired VIC (Video Input Card) installed
into the projector by pressing one of these buttons.
For details on the operations, refer to page 34.
5
Cursor (5/∞/2/3) button
Use this button in the menu mode to select an item or to
set or adjust the value.
For details on the operations, refer to pages 16 and 42.
10
1 2 3
STAND BY
HIDE
OPERATE
KEY STONE
q
4 5 6 7 8
VIC SELECT MENU
1
2
3
EXIT ENTER
w e
6
MENU button
Use this button to enter or exit from the menu mode. The
menu appears or disappears on the screen.
For details on the operations, refer to "Menu Operation
Procedure" page 42.
7
ZOOM T/W buttons
Use these buttons to adjust the projected screen size. (They
work only when the lens unit attached to this projector has
the zooming function.)
T (Tele) : The projected screen size decreases.
W (Wide) : The projected screen size increases.
For details on the operations, refer to page 35.
8
FOCUS +/– buttons
Use these buttons to adjust the focus of the projected video
image.
+ : The focus point becomes more distant.
– : The focus point becomes nearer.
For details on the operations, refer to page 35.
9
Remote sensor
When operating with the remote control unit, aim it at this
sensor. An additional remote sensor is provided on the
control panel of the projector. The effective operating
distance of the remote control is about 32.8 ft (10 m) from
each of the sensors. The effective operating range of angles
is 50° horizontally, and 15° vertically.
p
Status code display
A 2-digit number appears here to show the status of this
projector. Refer to the right.
T +
ZOOM
FOCUS
W –