Publicité
Les langues disponibles
Les langues disponibles
Installation
Prepare the Pool
Inspect the interior of your pool. If the liner is brittle, has wrinkles, root or metal corrosion from the underside,
or damage to the supporting base or walls, do not install the cleaner until a qualified professional makes
any necessary repairs.
1. Manually vacuum the pool if excessive debris is present,
and make sure the pool filter and pump basket are clean.
2. Adjust the return lines to blow downward
to break up surface circulation and
ensure complete cleaning coverage.
• Loosen the fitting lock ring
• Redirect the eyeball downward
• Retighten the lock
If the return fitting cannot be adjusted,
the fitting must be replaced with Zodiac
return line diverter (part #W90153 for 1-1/2",
#W90155 for 2" or #W24100 for pools
without return fittings) .
Assemble the Cleaner
Stretch the slotted disc over the foot pad with
the word "TOP" facing up. The disc should fit
securely in the groove and rotate freely
on the pad.
Slide the wheel deflector onto the extension
pipe and over the wheel adapter. The
deflector should rotate freely.
For corner or end installations, connect enough
hose to reach the farthest point of the pool and
then add one more section.
Skimmer
1 Hose
Section
4
For center installations, connect enough hose to
reach the farthest point of the pool and then add
two more sections.
Skimmer
2 Hose
Sections
Connect the Cleaner
1. Submerge the cleaner and flood it
with water.
2. When bubbles stop coming from the
extension pipe, connect the hose to
the cleaner.
3. Turn on the filtration system and fill the
hose with water by placing the end in
front of a return inlet until it is flooded.
Turn off the pump.
Connect the Hose
The FlowKeeper Valve must be used on all
installations. The valve regulates flow to ensure
the pool pump and cleaner run properly. It is pre-
set at the factory to optimize the performance of the
cleaner, but offers three settings to adjust the flow.
The lower the setting number, the lower the flow.
To adjust, pull the handle and move setting up
or down. The red tab can be used to open the
valve and stop the cleaner.
Install the FlowKeeper Valve with the arrow
facing down towards the skimmer pipe.
Using the parts as indicated, connect the hose
to the skimmer. For Canadian installations, the
hose protector attaches to the hose section that
goes into the skimmer.
Be sure to keep the hose and cleaner completely
submerged to keep air out of the system.
Once the hose is connected, turn on the
pool pump and begin cleaning. Installation
is complete.
Skimmer
or Wall
Vacuum
Line
45 Elbow
Hose
Protector
Net
FlowKeeper
Adjustment
Skimmer Installation
Hose Protector
(Canada only)
4-1/2"
Connector
45 Elbow
FlowKeeper
Valve
Valve
Cuff
5
FlowKee
4-1/2"
Valve
Connector
Va
C
Publicité
