handle, the machine will go to the right. The movements of the machine is very easily controlled, by simply
tilting the handle up or down.
While machine is in operation, care must be taken to keep extension cord away from rotating brush.
If the electrical cable is domanged, stop the machine and before to use it replace the cable by qualified
technicalmen.
WARNING: NEVER TURN ON MACHINE WHEN HANDLE IS IN UPRIGHT VERTICAL
POSITION BECAUSE THE MACHINE IS SUPPLYED OF SAFETY MICRO-SWITCH. THE "ON"
AND "OFF" MASTER SWITCH IS OPERATED BY MEANS OF LEVERS IMMEDIATELY UNDER
HANDLE GRIPS. WHEN TRANSPORTING OR STORING MACHINE, RAISE HANDLE TO
VERTICAL POSITION.
WARNING: MAINTENANCE SHOULD BE PERFORMED BY QUALIFIED PERSONNEL ONLY.
Lubrication: your machine has been completely lubricated at the factory before shipment to you.
The gear unit is lubricated for 2 or 3 years (for normal work).
Always remove brush from the machine when not in use. Brushes should be kept in a cool dry place as
excessive heat will warp and crack backing.
Extension cord: your machine has been equipped with 15 meters of cable. Should additional cable be
needed, use a larger size wire and always 3 wires.
Replace worn, cut or frayed electrical cables.
The Floor Maintener can be converted to many different uses. Following are the different types of brushes
available:
1) BASSINE BRUSH
2) NYLON BRUSH
3) NYLON-STEEL BRUSH
4) STEEL BRUSH
5) MOQUETTE BRUSH
6) PAD HOLDER
7) SYNTETIC PAD
It is possible to have also the solution tank for automatic solution feed.
POWER
PROTECTION CLASS
LENGTH OF CORDS
BRUSH SIZE
BRUSH
ENERGY SOURCE
VOLT
WEIGHT
MAINTENANCE OF MACHINE
CARE OF SCRUB AND POLISH BRUSHES
TECNICAL CHARACTERISTICS
1100W
1
15 m
500 mm
150 rpm
network current
230 V
45 Kg
8