FIORENTINI JOLLY 20 Instructions page 7

3) Organisational points
It is the responsibility of the operator to ensure that:
- The machine is used only by personnel who have been instructed in its handling and authorised to use it.
- The recognised occupational safety regulations are observed.
- Any further national or internal company regulations are observed.
- All users are acquainted with the safety regulations and trained in the use of the specific machine.
- All users have read and understood the operatin instructions.
- Responsabilities for the operation, maintenance and repair of the machine are clearly assigned and
observed.
- Faults and damage are immediately notified to the Service Agent of FIORENTINI.
4) Emergencies
In the case of an emergency:
- Pull out the mains connector plug.
- Immediately apply recognised first-aid measures.
After incidents, do not resume operation with the machine until it has been inspected by FIORENTINI
authorized technical.
5) Operating for the first time
Delivery, instruction on safety rules, handling and maintenance as well as operation for the first time must
be carried following the specification of this instruction book.
The operator is responsible for instructing the users.
FURTHER SAFETY INSTRUCTIONS CONCERNING OPERATING AND MAINTENANCE ARE
DETAILED IN THE RELEVANT SECTIONS AND MUST BE COMPLIED WITH!
IMPORTANT NOTES
Before starting to use the machine please observe the following points:
- If you should discover any damage when unpacking the machine please inform your sale agency.
- The supply voltage must be the same as that shown on the nameplate.
FOR ALL GROUNDED APPLIANCES
This appliance should be grounded while in use to protect the operator from elettric shock. The appliance is
equiped with an approval three-conductor european cord and three-prog grounding type plug to fit the
proper grounding type receptacle. The green (or green and yellow) conductor in the cord is the grounding
wire.
Never connect the green (or green and yellow) wire to a live terminal.
OPERATION OF MACHINE
Disconnect machine from power source before installing or removing brush, or before all cleaning operation
on the machine. Except for the brush, your machine has been completely assembled at the factory for
immediate operation. To assemble brush, tilt machine bacwards and line up lungs on gear unit with
openings on brush loking plate. Then turn brush in a clockwise direction, loking down on machine. To
operate, first rise looking cam lever located at lower part of handle. Lower the handle to best operating
position and tighten loking cam lever to hold handle in position. Your machine is now ready to operate. In
operating the machine you must remember that the machine will have a tendency to travel to the right or the
left depending if pressure is exerted on the front or rear of the brush. Therefore, when the operator lifts the
7