EGO ST1500 Guide D'utilisation page 12

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
WARNING:
assembling parts, making adjustments, cleaning, or when the product is not in use.
1. Remove the battery pack from the trimmer.
2. Loosen the four screws in the
handle with a Phillips screwdriver
(available separately) and remove
the screws, spring washers, flat
washers and lower clamp from the
handle (Fig. 6).
3. Attach the front-assist handle and
lower clamp on the shaft and secure
them by pre-tightening the four
screws. Turn the front-assist handle
upwards so that it points toward the
top of the handle (Fig. 7).
4. Adjust the front-assist handle
position between the rear handle
housing and the joint of the shaft,
as shown in Fig. 7. For ST1500,
adjust the handle position so that it
is between the rear handle housing
and warning label on the shaft.
Shorter users may adjust handle
to a lower position (away from you) and taller users may adjust the handle to an
upper position (towards you). The handle should be adjusted so that your front
arm will be straight when using the trimmer.
5. Tighten the four screws so that the handle cannot be rotated on the shaft.
12
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
Always remove battery the pack from the product when you are
6
7