Connecting The Module To The Media Center - Bose LIFESTYLE DVD Notice D'installation

English Deutsch Español Dansk

Connecting the module to the media center

Figure 11
Audio input cable
with a flat-sided multi-pin
connector at each end
Figure 12
Acoustimass connection
to the media center
Français Deutsch Italiano Nederlands Español
Use the audio input cable, which has a multi-pin connector at each end, to connect the
Acoustimass ® module to the media center (Figure 11).
Note: Before you make this connection, you can plug the power adapter into the media center
first, while there are no other cables in the way. However, DO NOT plug the adapter into the AC
(mains) power outlet before all other connections are completed.
1. With the flat side of the multi-pin connector facing down, insert one connector end into
the Audio jack labeled on the back of the Acoustimass module (Figure 12).
Be sure the connector is inserted flat side down.
2. Use the other end of the cable flat side up. Insert it into the Speakers jack labeled Main
on the media center.
Make sure that each connector is fully inserted into the jack.
Power adapter
cord
Speakers Main
Flat side up
CAUTION: Do not put strain on the audio input cable where it connects to the module and
media center. Excessive strain, caused by pulling directly on the cable or by compressing it, can
cause damage.
Français Svenska Italiano
Acoustimass module
connection panel
Main
Speakers jack
Media center
Audio input cable
connection panel
Nederlands Svenska
B S C
ASIC YSTEM ONNECTIONS
Flat side down
15