Dustcontrol DC 2800w Manuel D'instruction page 11

Warranty
The warranty period for this machine is two years
and covers manufacturers faults. The warranty is
valid under the condition that the machine is used
under normal conditions on the task for which it was
designed and is maintained properly.
TROUBLE SHOOTING
Problem
Motor will not start.
The motor stops directly
after starting.
Fan runs but no suction.
Fan runs but poor suction.
Evacuation pump
Abnormal sound from
machine.
Normal wear is not covered by this warranty. Service
performed by other than Dustcontrol or its autho-ri-
zed agent voids automatically the warranty. No other
warranty express or implied is applicable.
Fault
Machine not connected.
Incorrect fuse.
Hose plugged.
Hole in the hose.
Plugged fi lter.
Hose too long or too small.
Hose is kinked.
Float is stuck.
Drain hose to long.
functions poorly.
Drain hose plugged.
DC 2800w, 11
Solution
Make sure connection.
Change to correct circuit.
Find and remove block.
Change or repair hose.
Clean or change fi lter.
Change the hose.
Check and free.
Adjust the mounting.
Remove top and correct.
Shorten hose.
Remove and clear.
Order service.
Part No 9474