Safety Features; Operating Connections; High Pressure Hose; Water Connection - Powermate PW0501500 Manuel De L'utilisateur

2.0

SAFETY FEATURES

2.1 AUTOMATIC TOTAL STOP
The pressure washer is equipped with a stop device which
will sense when the trigger on the gun is released. It will open
the power circuit to the motor and cause the pressure washer
to stop.
WARNING: If Automatic Total Stop® fails to
operate, DO NOT USE THE MACHINE. Contact our
Customer Service department. Further use will
damage the machine and/or cause personal injury.
WARNING: The pressure washer is also equipped
with a main power ON/OFF switch located on the
unit. It should always be moved to the OFF position
when the pressure washer is not being used to
prevent possible injury or damage.
2.2 MOTOR OVERLOAD
The electric motor in this pressure washer is equipped with
an overload protection device which will automatically shut
off the motor in the event the motor draws excessive current
or overheats.
3.0

OPERATING CONNECTIONS

3.1

HIGH PRESSURE HOSE

Attach the high pressure hose by carefully inserting the fitting
with the o-ring into the high pressure outlet and tightening the
threader nut by hand.
3.2

WATER CONNECTION

Before connecting, run water through the garden hose (not
supplied), to flush out any foreign matter. Attach garden hose
to the pressure washer water inlet connection (see Fig 1). If
your water source is a well, the garden hose length can only
be 30 ft. max.
ATTENTION:
Proper water connection.
8
3.3
The pressure washer is factory-equipped with an electrical
cord. This cord should only be connected to an electrical
®
outlet installed in accordance with local safety regulations.
NOTE: The power supply must be 120V, 60 Hz and a
minimum 15 amp circuit. (Dedicated)
C. Keep all connections dry and off the ground.
D. Do not touch plug with wet hands.
If replacement of the plug or cord is needed, use only
identical replacement parts. Contact Customer Service for
proper replacement parts.

POWER SUPPLY CONNECTION

A. Connect only to a properly grounded outlet.
B. Inspect cord before using. Do not use if cord
is damaged.