Unloading The Dishwasher; Care And Cleaning; Cleaning The Filters - AEG FAVORIT 35410 VI Notice D'utilisation

74

Unloading the dishwasher

• Open the dishwasher door; press the programme selection/RESET button for about 3
seconds, until the light of the running programme turns off and the end of programme
indicator light flashes. The washing programme has been cancelled and the appliance is
now in setting mode.
• If a new washing programme is to be selected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and an audible signal informs you of the end of
the washing programme.
• Open the dishwasher door.
• The end of programme indicator light is illuminated.
• The indicator light of the programme just ended will remain on.
1. Switch off the dishwasher by pressing the On/Off button.
2. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
• Hot dishes are sensitive to knocks.
The dishes should therefore be allowed to cool down before removing from the appliance.
• Empty the lower basket first and then the upper one; this will avoid water dripping from
the upper basket onto the dishes in the lower one.
• Water may appear on the sides and the door of the dishwasher as the stainless steel will
eventually become cooler than the dishes.
CAUTION!
When the washing programme has finished, it is recommended that the dishwasher is
unplugged and the water tap turned off.

Care and cleaning

Cleaning the filters

The filters must be checked and cleaned from time to time. Dirty filters will degrade the
washing result.
WARNING!
Before cleaning the filters ensure that the machine is switched off.
1. Open the door, remove the lower basket.
All manuals and user guides at all-guides.com