PRO-POINT BMSY-315-E2 Manuel D'utilisateur page 12

19.0 cu. in. 2-Bolt Hydraulic disc Valve Geroler Motor
V 3.03
REPLACING THE SEALS
Lubricate all seals with grease or petroleum jelly before placing. A
clean plastic hammer may be required to tap the seals into place.
1. Fit the replacement O-ring (24) and O-ring (25) in the groove
of the channel plate (23).
2. Fit the replacement O-ring (15) in the groove on the end plate
(29).
3. Fit the replacement O-ring (15) into the groove on the balance
plate (20).
4. Fit the replacement O-ring (15) in the groove of the
intermediate plate (12).
5. Fit the replacement O-ring (9) into the groove of the housing
(2).
6. Remove and replace the shaft seal (3) from the housing (2).
Access the seal from the rear of the housing.
7. Remove and replace the dust seal (1) from the front of the
housing.
8. Go to section Rebuild the Motor.
Fig. 1
12 For technical questions call 1-800-665-8685
No. Description Qty.
1 Dust Seal
3 Shaft Seal
9 O-Ring
15 O-Ring
24 O-Ring
25 O-Ring
8490690
1
1
1
3
1
1