Dimplex TOLUCA DELUXE-EU Mode D'emploi page 6

Fuel Bed Media
Acrylic Ice Crystals and White Pebbles are supplied in the
box with your fire. allowing you the option of which to place
on your fire. To Fit the Acrylic Ice Crystals, place the small
Crystals on the fuel bed tray, then place the larger crystals
on top of the small pieces. Arrange the larger pieces to your
liking. A suggestion is to place one large crystal centrally on
the fuel bed and the other four positioned symmetrically
around this piece.
The White pebbles are placed on the fuel bed tray until the
tray is completely covered by pebbles to your liking.
Fitting the Front Glass- See Fig. 5
Your new fire is supplied with the front glass not secured to
the engine, this is to keep the glass safe in transit. To fit the
glass to your fire, simply insert the four hangers on the back
of the glass through the slots provided on the chassis. The
hangers go in through the slots and then move down to
hold the glass in place. The glass can then be secured in
place by inserting the small black screw provided through
the hole in any one of the hangers into the side of the unit.
Thermal Safety Cut-out
The built-in overheat cut-out switches the appliance off
automatically in the event of a fault. If this occurs switch off
the appliance or disconnect the mains plug from the socket.
After a short cooling down phase, the appliance is ready for
use again. If the fault should occur again, see your local dealer.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place
of traditional incandescent bulbs. These generate the same
light levels as traditional bulbs, but use a fraction of the energy
consumed.These bulbs cannot be replaced.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth.
DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be
used to clean the outlet grille of the fan heater.
WARNING: do not operate the product without the grille
and outer glass in position as this may effect the operation
of the heater.
Recycling
For electrical products sold within the
European Community. At the end of the
electrical products useful life it should not
be disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice in your country.
After Sales Service
Should you require after sales service or should you need
to purchase any spares, please contact the retailer from
whom the appliance was purchased or contact the
service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the first
instance as this may result in loss or damage and delay
in providing you with a satisfactory service. Please retain
your receipt as proof of purchase.