en Troubleshooting
Place the grease filters loosely into the dishwasher.
2.
Do not clean heavily soiled grease filters with
utensils.
Use special grease solvent for stubborn dirt. You
can obtain grease solvents from after-sales service
or the online shop.
Start the dishwasher.
3.
Select a temperature of no more than 70 °C.
Allow the grease filters to drain.
4.
7.7 Fitting grease filters
ATTENTION!
Falling grease filters may damage the hob below.
Grip below the grease filter with one hand.
▶
Fit the grease filters.
1.
Fold the grease filters upwards and engage the
2.
locks.
Make sure that the locks engage.
3.
7.8 Odour filter for recirculating air mode
Odour filters bind odorous substances in air recircula-
tion mode. Regularly replaced odour filters guarantee a
high level of odour removal.
With normal use (approx. one hour a day), the odour fil-
ter must be replaced every 4 months. The odour filter
cannot be cleaned or regenerated.
You can obtain odour filters from the after-sales service
or the online shop. Only use original odour filters.
Replacing the odour filter
Requirement: The grease filters have been removed.
To open the locking mechanism on the odour filter,
1.
rotate the odour filter.
8
Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
8
All manuals and user guides at all-guides.com
Remove the odour filter.
2.
Insert the new odour filter.
3.
To close the locking mechanism on the odour filter,
4.
rotate the odour filter.
7.9 Replacing the LED lights
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, unplug the appliance
▶
from the mains or switch off the circuit breaker in
the fuse box.
WARNING ‒ Risk of injury!
The light emitted by LED lights is very dazzling, and
can damage the eyes (risk group 1).
Do not look directly into the switched-on LED lights
▶
for longer than 100 seconds.
Note:
Only use bulbs of the same type and wattage.
Disconnect the appliance from the power supply.
1.
Remove the grease filters.
2.
→ "Removing the grease filter", Page 7
Unscrew the bulb and replace it with a bulb of the
3.
same type.
Install the grease filters.
4.
Insert the mains plug and switch on the fuse again.
5.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.