Focal FP Dual Direct Manuel D'utilisation page 14

T E C H N I C A L S P E C I F I C A T I O N S
Nominal power measured at 13.8V
continuously @ 4Ω
Nominal power measured at 13.8V
continuously @ 2Ω
Power in bridge mode measured at
13.8V continuously @ 4Ω
Power in bridge mode measured at
13.8V continuously @ 2Ω
Power supplies
Signal/noise ratio
Damping factor at 4Ω
Frequency response
Input impedance
Input sensibility
Analog input
Output stages
Operational amplifiers
Maximum cross section of loudspeaker
cables
Maximum cross section of power cables
Protections
Dimensions (H x W x D)
Weight
Comment: In our endeavour to continually improve our products, Focal reserves the right to modify the technical specifications of this product without prior notice.
2 x 250WRMS
2 x 400WRMS
1 x 800WRMS
1 x 1200WRMS
Dual fully regulated
> 110dB (A)
> 600
10Hz – 40kHz
13kΩ
0.2 – 5V
RCA
Transistors :
6 x Toshiba 2SC5200
6 x Toshiba 2SA1943
Burr-Brown®
10mm 2
7AWG
53mm 2
0AWG
Short-circuit
Continual power
Over-heating
Clipping limiter
Overvoltage
Polarity reversal
50 x 540 x 280mm (2 x 21.25 x 11")
7.5kg (16.53lb)
FP Dual Direct
14