Reversing The Door - Hisense RB372N4AC2 Mode D'emploi Pour L'utilisateur

Reversing the door

The side at which the door opens
can be changed, from the right side
(as supplied) to the left side, if the
installation site requires.
Warning! When reversing the door,
the appliance must not be connected
to the mains. Ensure that the plug is
removed from the mains socket.
Tools you will need
Not provided
8mm socket wrench
Cross-shaped screwdriver
When required, tilt the refrigerator
●
back in order to gain access to the
base, you should rest the appliance
on soft foam packaging or similar
material to avoid damaging the
backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
Different models may correspond to
different pictures. Models will be
written in the picture. If some parts
are not shown in the picture, please
ignore the relevant description.
1. Stand the refrigerator upright.
Open the upper door to take out all
door racks (to avoid racks damaged)
and then close the door.
Thin-blade screwdriver
8mm wrench
Door racks
2.Remove part ①,
the top right side of refrigerator.
① Self-tapping
② Upper hinge cover
MODEL WITHOUT DISPLAY
3.Remove screws
② .When the refrigerator with
display on door, you need to pass
connector ③ through the hole of
hinge ②. (Please hold upper door by
hand when installing).
① Special flange
② Upper hinge
MODEL WITHOUT DISPLAY
① Special flange
② Upper hinge
③ Electrical connector
MODEL WITH DISPLAY
10
loose part ② from
screws
① and hinge
screws
screws