Télécharger Imprimer la page

Leveling Of Appliance; Door Removal - Hisense RF254N6CSE Guide D'utilisation Et D'entretien

Publicité

Les langues disponibles

Les langues disponibles

Leveling of appliance

For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6".
0.4"~0.6"
Front roller
Adjustable
bottom feet

Door Removal

Tools you will need(Not provided):
1. With the door closed, remove the 3 screws
2.
Rear roller
Adjustable
bottom feet
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed
to 'Installing Water Lines' on page 7. If
you need to remove the doors,
continue below.
Allen Wrench (5/32",4mm)
Philips Screwdriver
holding the top cover (1) with Philips (+)
screwdriver, and then remove the top
cover with the entire harness attached.
Separate the two connectors on the left
side door. To remove the wire connector,
press the top of the connector (2) and
separate it from the other one. To remove
the water coupler from the hinge, twist and
pull the clips from the coupler. Remove the
water line (3) while pressing the movable
part (4) of the water line coupler.
Wrench (5/16",8mm)
Clip
5

Publicité

Chapitres

loading