Publicité
Les langues disponibles
Les langues disponibles
POLYGLASS MULTI SPEAKER
U s e r
M a n u a l
Cables and connections
• For best results with your Polyglass speakers, we recommend you include the use of
Focal cables.
• Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness = 1mm2). This is particularly important for long lengths of cable to
ensure a strong efficient signal is maintained.
• Always ensure the polarity is respected, (+ is connected to +) and (- is connected to -).
• Maintain correct connections, from principal source radio / amplifier (left / right / front and
rear), and crossover to speakers (tweeter to tweeter), (mid to mid)*, (woofer to woofer), is
always observed.
* For the 3 way models 165V3E and 270V3, the midrange is not shown.
Fitting the tweeter
There are two mounting possibilities available:
surface or flush mount. The TN47 arrives supplied
in its flush-mounting pod. Very carefully, remove the
grille, by gently prizing it off (using a pointed tool),
then use the unlocking tool provided to turn the
tweeter and to remove it of its seating.
Surface mounting: Choose the angle that best
suits your installation (10° or 30°) and mount the
pod firmly using the screws supplied. Feed the wire
through the hole in the pod and re-fit the tweeter and
grille in place.
Flush mounting: Cut a neat 40mm diameter hole in
the panel where you want to place the tweeter. Then with the metal mounting strip held from
behind (ensuring the ends are pointing towards the hole), insert the screw through the flush-
mount pod from the front and tighten the two parts together. Feed the wire through the hole
in the pod and re-fit the tweeter and grille in place.
Right Output
Input
Left Output
Input
Woofer
Tweeter
Woofer
Tweeter
Grille
Unlocking tool
Tweeter
Pod
Mounting strip
3
Publicité
