Tripp-Lite SMART2500XLHG Manuel Du Propriétaire page 9

Basic Operation
"BATTERY WARNING" LED: This LED illuminates yellow and an alarm
sounds intermittently after you initiate a self test (See "MUTE/TEST" Button
description) to indicate the UPS batteries need to be recharged or replaced.
Allow the UPS to recharge continuously for 12 hours, and repeat the self-
test. If the LED continues to light, contact Tripp Lite for service. If your UPS
requires battery replacement, visit www.tripplite.com to locate the specific
Tripp Lite replacement battery for your UPS.
Other UPS Features (Rear Panel)
AC Receptacles: Your UPS features NEMA 5-15/20 and IEC C13 AC
outlets. These output receptacles provide your connected equipment with
AC line power during normal operation and battery power during blackouts
and brownouts. The UPS protects equipment connected to these
receptacles against damaging surges and line noise.
NEMA 15/20
IEC C13
Equipotential Connection: Use this to connect any equipment that
requires a chassis ground. Connect the equipment's ground wire to the UPS
at this point and screw the included thumbscrew into the UPS to secure the
connection.
Communications Ports (USB or RS-232): These ports connect your UPS
to a workstation or server. Use with Tripp Lite's PowerAlert Software and
included cables to enable your computer to automatically save open files
and shut down equipment during a blackout. Also use PowerAlert Software
to monitor a wide variety of AC line power and UPS operating conditions.
Consult your PowerAlert Software manual or contact Tripp Lite Customer
USB
Support for more information. See "USB and RS-232 Serial
Communications" in the "Optional Installation" section for installation
instructions.
RS-232
EPO (Emergency Power Off) Port: Your UPS features an EPO port that
may be used to connect the UPS to a contact closure switch to enable
emergency inverter shutdown. See "Optional Installation" section.
Accessory Slot: Remove the small cover panel from this slot to install
optional accessories to remotely monitor and control your UPS. Refer to
your accessory's manual for installation instructions. Contact Tripp Lite
Customer Support at 773.869.1234 for more information, including a list
of available SNMP , network management and connectivity products.
9
16-07-007-933607.indb 9 8/31/2016 10:04:08 AM