Publicité
Les langues disponibles
Les langues disponibles
Read, understand, and follow all safety information contained in these instruc-
tions prior to installation and use of the Aqua-Pure
tions for future reference.
Intended use:
The AP101T, AP11T, AP141T and AP102T Whole House Filters are intended for use in fi ltering
potable water in homes and have not been evaluated for other uses. These fi lters are typically
installed at the point of entry, and should be installed by qualifi ed professional installers ac-
cording to these installation instructions.
EXPLANATION OF SIGNAL WORD CONSEQUENCES
WARNING
CAUTION
To reduce the risk associated with ingestion of contaminants due to use with water
that is microbiologically unsafe or of unknown quality:
• Do not use with water that is microbiologically unsafe or of unknown quality without ad-
equate disinfection before or after the system.
To reduce the risk associated with property damage due to water leakage:
• Read and follow Use Instructions before installation and use of this system.
• Installation and Use MUST comply with all state and local plumbing codes.
• Protect from freezing. Drain fi lter when temperatures drop below 40°F (4.4°C).
• Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure exceeds
125 psi, you must install a pressure limiting valve. Contact a plumbing professional if you
are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions
exist you must install a water hammer arrester. Contact a plumbing professional if you are
uncertain how to check for this condition.
• Install on COLD water lines only. (40-100°F (4.4-37.8°C))
• The disposable fi lter cartridge must be replaced every six months or at the specifi ed
service cycle.
• Do not use a torch or other high temperature sources near fi lter or plastic fi ttings.
• Mount fi lter in such a position as to prevent it from being struck by other items used in the
area of installation (waste baskets, etc).
• Take care when using pliers or pipe wrenches to tighten plastic fi ttings.
• On plastic fi ttings, never use pipe sealant or pipe dope. Use thread sealing tape only.
• Shut off fuel supply to water heater after water is shut off.
• Ensure all tubing and fi ttings are secure and free of leaks.
• DO NOT leave valve-in-head models in "OFF" position for an extended period of time or
use as a substitute for main water line valve if line must be shut off for servicing.
• Failure to follow instructions may void warranty.
• Allow a minimum of 2" (5 cm) clear space under fi lter to facilitate cartridge change.
• Install with the inlet and outlet ports as labeled. Make sure not to reverse connections.
SAFETY INFORMATION
Indicates a potentially hazardous situation, which, if not avoided, could
result in death or serious injury and/or property damage.
Indicates a potentially hazardous situation, which, if not avoided, may
result in property damage.
WARNING
CAUTION
IMPORTANT NOTES
®
fi lters. Retain these instruc-
Publicité
