Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

3M
Water Filtration Products
Installation and Operating Instructions for
AP902/AP903 Series
Whole House Water Filters
Read, understand, and follow all safety information contained in these instructions
prior to installation and use of the 3M™ Water Filtration Products AP902/AP903 Series
of Water Filters. Retain these instructions for future reference.
The AP902/AP903 Series of Water Filters is intended for use in fi ltering potable water in Whole House
applications and has not been evaluated for other uses. These fi lters are typically installed at the point-
of-entry, and must be installed as specifi ed in the installation instructions.
EXPLANATION OF SIGNAL WORD CONSEQUENCES
WARNING
WARNING
Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or property damage.
CAUTION
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury and/or property damage.
CAUTION
CAUTION
Indicates a potentially hazardous situation, which, if not avoided, may result in property damage.
To reduce the risk associated with with choking:
• Do not allow children under 3 years of age to have access to small parts during the installation of this product.
To reduce the risk associated with the ingestion of contaminants:
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
To reduce the risk associated with hazardous voltage due to an installer drilling through existing electric wiring or water pipes in the area
of installation:
• Do not install near electric wiring or piping which may be in path of a drilling tool when selecting the position to mount the fi lter bracket.
To reduce the risk of physical injury:
• Depressurize system as shown in manual prior to cartridge removal.
To reduce the risk associated with back strain:
• Follow safe lifting procedures
To reduce the risk associated with property damage due to water leakage:
• Read and follow Use Instructions before installation and use of this system.
• Before starting installation, shut off main water supply and drain pipes.
• Installation and Use MUST comply with all state and local plumbing codes.
• Protect from freezing, remove cartridge when temperatures are expected to drop below 40° F (4.4° C);
• Do not install on hot water supply lines. The maximum operating water temperature of this fi lter system is 100°F (37.8°C).
• Do not install if water pressure exceeds 100 psi (689 kPa). If your water pressure exceeds 80 psi (552 kPa) you must install a pressure
limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions exist, you must install a water hammer arrester. Contact
a plumbing professional if you are uncertain how to check for this condition.
• Do not use a torch or other high temperature sources near fi lter system, cartridges, plastic fi ttings or plastic plumbing.
• On plastic fi ttings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may deteriorate plastic.
• Take care when using pliers or pipe wrenches to tighten plastic fi ttings, as damage may occur if overtightening occurs.
• Do not install in direct sunlight or outdoors.
• Do not install near water pipes which will be in path of a drilling tool when selecting the position to mount the bracket.
• Mount fi lter in such a position as to prevent it from being struck by other items used in the area of installation.
• Ensure that the location and fasteners will support the weight of the system when installed.
• Ensure all tubing and fi ttings are secure and free of leaks.
• The disposable fi lter cartridge MUST be replaced every 12 months or at the rated capacity or if a noticable reduction in fl ow rate occurs.
• Failure to follow instructions may void warranty.
• Allow a minimum of 3" (7.6 cm) clear space under fi lter to facilitate cartridge change.
• Install with the inlet and outlet ports as labeled. Make sure not to reverse connections.
• Some local codes may require the use of a licensed plumber or certifi ed installer when disrupting a potable water line.
Installer: Please leave this manual with owner/operator.
Homeowner: Please retain for operation and future maintenance instructions.
WARNING
.
CAUTION
IMPORTANT NOTES

Publicité

Table des Matières
loading

Sommaire des Matières pour 3M AP902 Serie

  • Page 1 Whole House Water Filters Read, understand, and follow all safety information contained in these instructions prior to installation and use of the 3M™ Water Filtration Products AP902/AP903 Series of Water Filters. Retain these instructions for future reference. The AP902/AP903 Series of Water Filters is intended for use in fi ltering potable water in Whole House applications and has not been evaluated for other uses.
  • Page 2: Getting Started

    GETTING STARTED Assembly schematic is based on suggested materials. Assembly of this filter can be modified by using various adapters. Parts and Materials Included: 1) Filter Head 2) Filter Cartridge Tools and Materials Required (not included): Gather the required tools before starting installation. Read and follow the instructions provided with any tools listed here.
  • Page 3: Important Installation Instructions

    IMPORTANT INSTALLATION INSTRUCTIONS CAUTION To reduce the risk associated with property damage due to water leakage: • On plastic fi ttings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may deteriorate plastic. • Take care when using pliers or pipe wrenches to tighten plastic fi ttings, as damage may occur if overtightening occurs. 1.
  • Page 4: Troubleshooting Guide

    400 Research Parkway Meriden, CT 06450, USA Toll Free: 1.888.218.CUNO © 2008 3M Company. All rights reserved. Worldwide: 203.237.5541 3M is a trademark of 3M Company. CUNO is a trademark of 3M Company used under license. Fax: 203.238.8701 INSTR2163 0508 www.cuno.com...
  • Page 5 Lea, entienda y siga toda la información de seguridad incluida en estas instrucciones antes de instalar y utilizar los productos para la fi ltración de agua 3M™, fi ltros de agua de la serie AP902/AP903. Guarde estas instrucciones para futuras consultas.
  • Page 6 INTRODUCCIÓN El diagrama de ensamblaje se basa en los materiales recomendados. El ensamblaje de este filtro puede modificarse utilizando diversos adaptadores. Partes y materiales incluidos: 1) Cabeza del filtro 2) Cartucho del filtro Herramientas y materiales requeridos (no incluidos): Reúna las herramientas requeridas antes de comenzar la instalación. Lea y siga las instrucciones provistas con todas las herramientas que se mencionan aquí.
  • Page 7 IMPORTANTES INSTRUCCIONES DE INSTALACIÓN PRECAUCIÓN Para reducir el riesgo asociado con daños a la propiedad por pérdidas de agua: • No utilice sellador de roscas ni grasa para roscas en accesorios plásticos. Utilice únicamente cinta para roscas de PTFE. Las propiedades de la grasa para roscas pueden deteriorar el plástico.
  • Page 8: Guía De Resolución De Problemas

    400 Research Parkway Meriden, CT 06450, USA Gratis: 1.888.218.CUNO © 2008 3M Company. Todos derechos reservados. Teléfono: 203.237.5541 3M es marca registrada de 3M Company. Fax: 203.238.8701 CUNO es marca registrada de 3M Company y uso está bajo licencia. www.cuno.com INSTR2163 0508...
  • Page 9 Directives d’installation et mode d’emploi pour séries AP902/AP903 Filtres à eau pour toute la maison Avant d’installer et d’utiliser ces produits de fi ltration de l’eau 3M de séries AP902/ AP903, s’assurer de lire, comprendre et suivre toutes les consignes de sécurité que renferme ce mode d’emploi.
  • Page 10: Démarrage

    DÉMARRAGE Le schéma de montage se base sur les matériaux suggérés. Le montage de ce filtre peut être modifié en utilisant divers adaptateurs. Pièces et matériel inclus : 1) Tête du filtre 2) Cartouche filtrante Outils et fournitures nécessaires (non compris) : Il est recommandé...
  • Page 11 DIRECTIVES D’INSTALLATION IMPORTANTES ATTENTION Afi n de réduire les risques de dommages matériels associés aux fuites d’eau : • Ne pas utiliser de garniture d’étanchéité ou d’enduit d’enrobage avec les raccordements de plastique. Utiliser uniquement du ruban d’étanchéité PTFE, car les composants de l’enduit d’enrobage sont susceptibles de détériorer le plastique. •...
  • Page 12: Directives De Remplacement De La Cartouche Filtrante

    Numéro vert : 1.888.218.CUNO © 2008 3M Company. Tous droits réservés. Mondial : 203.237.5541 3M est de marque de commerce de 3M Company, Inc. Télécopie : 203.238.8701 CUNO est de marque de commerce de 3M Company, Inc. utilisées avec autorisation. www.cuno.com INSTR2163 0508...

Ce manuel est également adapté pour:

Ap903 serie

Table des Matières