Tripp-Lite SRCOOL18K Manuel Du Propriétaire page 8

Installation
(continued)
Window Exhaust Connection
5
Note: The SRCOOL18K and SRCOOL24K both contain two adjustable exhaust panels (one for each warm air exhaust duct). Repeat steps
through 5-3 to install the second exhaust panel.
Warning: Some windows may require modified installation procedures. The user must determine the fitness of hardware
and procedures before installing. The procedures described in this manual may not be appropriate for all applications. The
exhaust panels are not designed to be installed stacked on top of one another or side-by-side. Each exhaust panel can
occupy one window pane.
5-1
Measure the window opening. Combine the two sections of the adjustable exhaust panel,
then adjust the exhaust panel to match the width of the window opening. After the exhaust
panel is set to the correct width, use the included self-tapping screw to lock it in place.
Note: The exhaust panel can adjust from 20.5 to 49.2 inches (52.1 to 104.1 cm). It is
compatible with vertical and horizontal mounting.
5-2
Insert the exhaust duct adapter into the oblong hole in the adjustable exhaust panel. The
adapter will snap into place. Repeat for the second exhaust duct tube.
Insert the exhaust panels into the window opening, then close the window against the
5-3
exhaust panels. A tight seal will permit maximum cooling efficiency.
Note: There must be at least 20 inches (50.8 cm) of open space behind the rear panel to
allow adequate airflow.
Note: The flexible exhaust duct can extend to a maximum length of 118 inches (300 cm).
Provide the straightest, shortest path available. Excessive bending or stretching of the duct
will reduce cooling efficiency.
INCORRECT CORRECT
8
Self-Tapping Screw
5-1
Horizontal Window
Opening
Self-Tapping Screw
Horizontal Window
Opening
Self-Tapping Screw
5-2
Horizontal Window
Opening
5-3
5-1
Vertical
Window
Opening
Vertical
Vertical
Window
Window
Opening
Opening