Tripp-Lite SRCOOL18K Manuel Du Propriétaire page 6

Installation
(continued)
2-2
Align the cooling duct adapter with the cool air output
secure it to the unit with the screws used for securing the pre-installed louvered vent
Note: The SRCOOL24K cooling duct adapter requires four additional screws (included).
Connect the flexible black cooling duct
2-3
tube A to the cooling duct adapter
Align the duct with the circular adapter
opening, push the duct downward and
turn the duct clockwise until it screws
into the adapter solidly.
Place the other end of the cooling duct near
2-4
the air intake of the target device or rack
enclosure, using the straightest, shortest
path available (for SRCOOL24K, repeat with
the second cooling duct). If you plan to
cool a rack enclosure, place the end of the
cooling duct over a perforated area near the
top of the enclosure's front door (or near the
top of the bank of equipment that requires
cooling). Cool air will sink and spread across
the air intakes at the front of the rack
enclosure.
. Using a Phillips screwdriver,
A
B .
A
2-3
2-4
6
B .
B
A
SRCOOL18K
2-2
B
A
SRCOOL18K
SRCOOL18K
B
A
SRCOOL24K
B
SRCOOL24K
SRCOOL24K