Steam Cleaning - Black+Decker HSM13E1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


CAUTION: Never leave the steam mop in one spot on
any surface for any period of time. Always place the
steam mop with the handle tube
upright position when stationary and make sure the
steam mop is turned off when not in use.

CAUTION: Always empty the steam mop after use.
nOTE: When first filled or after running dry, it can take up to
45 seconds for steam to be produced.
Hints for optimum use

WARNING: It is important to monitor the water level
in the water tank. To refill the water tank and continue
to sanitize/ clean, see Filling the Water Tank section.
nOTiCE: Never leave the steam mop in one spot on any
surface for any period of time. Do not store with a wet pad
as this can damage your floor. Always place the steam
mop with the handle tube
stationary and make sure the steam mop is turned off when
not in use.
Always vacuum or sweep the floor before
using the steam mop.
The easiest way to use the steam mop is to tilt the
handle to a 45˚ angle and clean slowly, covering a small
area at a time.
Do not use chemical cleaners with your steam
mop. To remove stubborn stains from vinyl or linoleum
floors, you can pre-treat them with a mild detergent and
some water before using the steam mop.

Steam Cleaning

1. Place a cleaning pad
facing up.
2. Lightly press the steam mop down onto the cleaning
pad
7
.
3. Plug the steam mop into a wall outlet.
4. Press the ON/OFF button
15-30 seconds for the steam mop to heat up.
5. Press the steam operate button
steam will start to come out of the steam head.
nOTiCE: If the system has been run dry it may take up to 45
seconds to prime the system on first use.
6. It takes a few seconds for steam to enter the cleaning
pad. The steam mop will now glide easily over the
surface to be sanitized/cleaned.
7. Push and pull the steam mop slowly across the surface
to thoroughly steam clean each section.
8. When you have finished using the steam mop, return
the handle tube
9
to the upright position, making
sure that it is supported and turn it 'OFF'. Wait until the
steam mop cools down (approximately five minutes).

CAUTION: It is important to monitor the water level
in the water tank
continue to sanitize/clean stand the mop upright
making sure that the handle is supported and turn the
steam mop 'OFF'. Unplug the unit from the electrical
wall outlet, refill the water tank
9
supported in the
in the upright position when
 9 
7
on the floor with the 'loop' side
. It takes approximately
1
2
. After a few seconds,
. To refill the water tank and
4
.
4

CAUTION: Never leave the steam mop in one spot on
any surface for any period of time. Always place the
steam mop with the handle tube
upright position when stationary and make sure the
steam mop is turned off when not in use.
After use (Fig. F)
1. Turn the steam operate button
the ON/OFF button
1
2. Wait until the steam mop cools down.
3. Unplug the steam mop from the electrical wall outlet.
4. Empty the water tank.
5. Remove the cleaning pad
be ready for the next use.
nOTE: Follow cleaning instructions located on the pad.
6. Wrap the power cord so that it loosely hangs from the
cord hook
10
.
Fig. F
10
MAINTENANCE AND CLEANING
Your BLACK+DECKER corded appliance has been designed
to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper appliance care and regular cleaning.

WARNING: Before performing any maintenance or
cleaning on corded appliances switch off and unplug
the appliance.
Clean your appliance using a soft damp cloth. Never
let any liquid get inside the appliance; never immerse
any part of the appliance into a liquid. IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed
by authorized service centers or other qualified service
organizations, always using identical replacement parts.
For stubborn marks you can use a mild solution of soap
and water to dampen your cloth.
Care of the cleaning pads
nOTiCE: Follow the cleaning instructions printed on the
label of your cleaning pad.
English
9
supported in the
to Off and then press
2
.
and wash it so that it will
7
11
5

Publicité

Table des Matières
loading

Table des Matières