Xpelair VX100 Instructions D'installation Et D'entretien page 7

4. Align the holes in the back plate with those in
the spacer.
5. Insert two of the ended self-tapping
screws provided in the
fasten the back plate to the spacer. Do not
overtighten the screws.
Wire the electrical connections
Make sure the mains supply is isolated,
1. Wire the fan as shown in
model to diagram, feeding the cable between
the two raised pegs, if wiring from above, and
through labyrinth to terminal block.
2. Switch the mains electrical supply and
remove fuses
3. Connect the cable from the isolating switch to
the electrical supply wiring.
For xed wiring circuits the protective
fuse for the appliance must not exceed
5A.
VX100T only I
To adjust the over-run period turn the control
(T) clockwise to increase and anti-clockwise
to decrease.
All fans
If wiring from above cut out the cable entry
slot marked on top of the front cover.
Fit the front cover by aligning it square to the
duct and pushing it onto the duct until the
release catches snap into the slots on the
front cover.
Using the fan
VX100 only
Operate the fan using the
Repeat to switch o .
VX100P only
Operate the fan by pulling and releasing the
cord. Repeat to switch o .
VX100T only
Operate the fan using the
the switch is turned o , the fan continues to
operate for the adjustable time delay.
Cleaning (recommended once a month)
A QUALIFIED ELECTRICIAN MUST CARRY
OUT ALL CLEANING.
holes, and
1. Before cleaning, isolate the fan completely
2. Remove the front cover by pressing the
H check the fan
3. To clean the front cover, either wipe it with a
4. Do not immerse the fan in water or other
5. Never use strong solvents to clean the fan.
6. Apart from cleaning, no other maintenance is
switch.
switch. When
from the mains supply.
release catches located on the sides at the
unit with a 3mm screwdriver, whilst pulling the
front cover forward L
damp, lint free cloth or wash it in warm soapy
water. Thoroughly dry the front cover and
liquids to clean any other parts of the fan.
required.
7