Positioning The Range - Heartland 9200 Instructions D'installation Et D'utilisation

Back of stove
Exhaust Hood In
(female receptacle,
from closet
Model 9200

Positioning the Range

1. When the range is fully assembled, recheck all electrical connections especially between
the exhaust hood and the back of the range. As well, check that all nuts and bolts have been
tightened.
2. Ensure teflon gliders and flooring are clean.
3. Caution: On flooring with very rough surfaces or deep, large grooves the appliance may
have to be lifted and slowly slid into position.
4. Put both hands on the trim and carefully push the range into place. Make sure floor is clear
of all debris. Don't forget to plug in the main power cord and the exhaust hood power
cable before the range is in its final position. See closet installation instructions.
5. To level the range, simply adjust the levelling screws with teflon pads located at the bottom
of each leg. Using a 5/16" (8 mm) open-end wrench, turn the adjusting screw clockwise to
raise up the corner, and counter-clockwise to lower the corner. (Don't forget the teflon glider
should extend beyond the bottom of the leg by approximately 1/8"-1/4".)
6. Note: On soft kitchen flooring, the weight of the stove may cause slight depressions in the
flooring. When the range is in position and levelled, you may want to place coasters under the
teflon gliders of each leg to protect the floor. Remove the coasters when moving the range for
cleaning or servicing.
)
Power In
(male receptacle)
Back of stove
Power In
(male receptacle)
Exhaust Hood In
(female receptacle,
from
Model 7200
8
closet
)