Data Plate - SCHOLTES PPF 20DC 120 Mode D'emploi

! If the appliance is connected to liquid gas, the regulation
GB
screw must be fastened as tightly as possible.
! Once this procedure is finished, replace the old rating
sticker with one indicating the new type of gas used.
Stickers are available from any of our Service Centres.
! Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet pipe (in order
to comply with current national regulations).
Fig.5
Fig.7

DATA PLATE

Electrical
connections
18
Fig.6
voltage of 220-240V ~ 50/60Hz
(see data plate )
This appliance conforms to the
following European Economic
Community directives:
-2006/95/EEC dated 12/12/06 (Low
Voltage) and subsequent
amendments
- 2004/108/EEC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2009/142/EEC dated 30/11/09
(Gas) and subsequent
amendments.
- 2002/96/EC and subsequent
amendments.
Note for hob model B 30TC 138/CS BNV only Note for hob model B 30TC 138/CS BNV only Note for hob model B 30TC 138/CS BNV only
Note for hob model B 30TC 138/CS BNV only Note for hob model B 30TC 138/CS BNV only
B 30TC 138/CS BNV model hobs are equipped with two
gas supply inlets (see fig. 6, details P1 and P2) and each
one controls two burners; both inlets should therefore be
connected to the gas supply network.
A
R1 R2