Metabo HPT CJ36DA Instructions De Sécurité Et Mode D'emploi page 21

NOTE
Circular cutting must be done with the blade
approximately vertical to the bottom surface of the
base.
4. Cutting metallic materials (Fig. 29)
(1) Adjust the speed Dial between scales "3" and "4".
(2) Set the orbital position to "0" or to the position
indicated in the fi gure.
Dial
Oiler
Change knob
NOTE
Always use an appropriate cutting fl uid (spindle oil,
soapy water, etc.). When a liquid cutting fl uid is not
avaiable, apply grease to the back surface of the
material to be cut.
5. Pocket cutting (Fig. 30)
(1) Loosen the base bolt allen wrench attached on base.
(Fig. 25)
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 25)
(3) Set the orbital position to "0".
<In lumber>
Aligning the blade direction with the grain of the
wood, cut step by step until a window hole is cut in the
center of the lumber.
<In other materials>
When cutting a window hole in materials other than
lumber, initially bore a hole with a drill or similar tool
from which to start cutting.
3 - 4
Fig. 29
Fig. 30
6. Angular cutting
The base can be swiveled to both sides by up to 45°
for angular cutting. (Fig. 31)
Base
45°
45°
(1) Loosen the base bolt by allen wrench attached on
base and move the base fully forward. (Fig. 25)
(2) Align the scale (from 0 degrees to 45 degrees by
15-degree increments) of the semi-circular part
of the base with the [ ] mark on the gear cover.
(Fig. 32)
Scale
(3) Tighten the base bolt again. (Fig. 25)
(4) Set the orbital position to "0" - "ІІІ".
NOTE
Angular cutting can not be done when adopting chip
cover or dust collector.
English
45
Semi-
circular
part
Scale
45
Fig. 31
mark
Semi-circular part
Fig. 32
mark
21