Malfunction Table - Dibo PTL Mode D'emploi

E N
M a l F u n C T I o n Ta B l E
MALFUNCTION
Machine does not start
no water pressure
Instable and to weak pressure
hp pump pulse
Fuel engine: no start or no functioning. See
also manual engine.

Malfunction table

at a possible malfunction one can consult the table mentioned below and if you
obtain on this basis no solution, we advise to contact a DiBo technician and/or
a recognized DiBo representative.
CAUSE
• Battery tension too low
• operation switch "oFF"
• Start engine does not work
• Too few oil in engine casing
• Rest malfunctions
• To few water inlet
• Filter stuffed-up
• air in water supply (leaks in water
supply)
• nozzle or lance stuffed-up or worn-
out.
• pressure regulator defect
• Rest malfunctions
• leak or congestion in supply
conduit
• To much air present
• no fuel supply
• no air supply
• Engine overloaded
• Glow plug fault or defective
• oil level incorrrect
• Cooling fins polluted
• other malfunctions
DiBO 26
SOLUTION
• loads battery
• operation switch "on"
• Consult an expert
• Refill oil
• Consult an expert
• Repair water inlet
• Clean/replace filter cartridge
• put machine completely without
power! Repair leaks in supply.
• Clean or replace
• Consult an expert
• Consult an expert
• Clean/replace/repair
• De-aeration of cleanerr
• Check fuel tank on pollution/level/
fuel quality
• Check/clean air filter
• Cool the engine & turn off (xx time)
• Check the glow plug.
Consult an expert when defective.
• Refill oil and/or replace. Check oil
filter and/or replace.
• Clean the engine with a brush
• Consult an expert