Prima PP 35 Manuel D'instructions page 9

Technical Data Table
A Cutting circuit data:
No-load Voltage (Uo)
Cutting voltage and current (I2/U2)
Use intermittence ratio (X)
B Mains Data:
Phase number
Thermic insulation class
Cooling type
Case protection degree
Mains voltage and frequency (U1/Hz)
Absorbed apparent current/power (I1/S1) and relevant power factor (cosphi)
Delayed fuses to be used
TORCH (13)
√ √ √ √ √
The torch button is the only one control device which can start and stop cutting operations.
√ √ √ √ √
When button is released the cycle is immediately and always stopped with the exception of cooling
air (post-air).
√ √ √ √ √
Accidental manoeuvres: in order to start cycle button must be pressed at least 500ms.
1 LINE VOLTAGE
2 RED LED:
3 YELLOW LED: THERMAL CUTOUT
4 YELLOW LED: AIR PRESSURE FAULT
5 AIR TEST TRIGGER
6 MAIN SWITCH
7 INPUT CABLE
CUTTING CIRCUIT ON
8 RED LED: ABNORMAL VOLTAGE
9 PRESSURE REDUCER
10 CUTTING CURRENT POTENTIOMETER
11 GAUGE
12 DINSE SOCKET
13 TORCH
9