Krups FNA1 Mode D'emploi page 14

. place a cup beneath the coffee outlet, and
the capsule holder head must be closed and
empty.
. set the function selector (b) to the «
position.
. once the cup is full, reset the function
selector (b) to the central position.
As soon as the temperature indicator light (e)
becomes fixed (green), you can start to
prepare an espresso or hot water.
. THE HOT WATER FUNCTION
• Fill the tank (a) with fresh water (1) and
position the switch (c) to «I». The
temperature indicator light (e) flashes
(green).
Once the appliance reaches the correct
temperature, the temperature indicator light
(e) becomes fixed (green).
• Place a container under the steam/hot water
nozzle (g).
• Set the function selector (b) to the « »
position : hot water will come out of the
nozzle (g).
• Stop the flow of hot water by returning the
function selector (b) to the central position.
Note :
• Follow this operation to preheat cups before
making an espresso.
Cleaning
• Before doing any cleaning of the appliance,
unplug it.
• Do not wash the accessories of your
appliance in the dishwasher.
• Clean the body of the appliance using a
damp cloth.
• After use, always empty the water tank.
. Drip tray (i) and container for used
capsules (j)
• After every use, the drip tray will fill with
water. This is perfectly normal. The fill
indicator (i1), indicates when to empty the
tray.
• Remove the grille and the fill indicator (i1),
take out the container and empty the drip
tray (6).
14
• If necessary, clean the drip tray with hot
water and a little non-abrasive washing-up
liquid, rinse and dry. When refitting, put
back the container, the indicator then the
»
grille.
. The steam / hot water nozzle (g)
Be careful : it may still be burning hot.
• Clean the nozzle after every use using a
damp cloth.
• If the opening in the nozzle outlet is
blocked, clear it using a fine needle.
. Cappuccino accessory (h)
• To completely clean the cappuccino
accessory, separate parts A, B and C (7).
• Rinse the three parts in hot water and dry
them.
• If the small hole in part A is blocked, clean it
using a fine needle.
Descaling
Descale your appliance at regular
intervals !
Descaling your NESPRESSO is essential to
guarantee that your appliance is working at its
best, will last for a long time and produce top
quality coffee.
Depending on how hard the water is in your
region, this descaling should be performed
every two to six months. However, if the
water in your region is very hard or if you use
the appliance a great deal, it would be
advisable to do this more frequently.
The NESPRESSO Club will supply you with a
descaling kit comprising a sachet of descaling
product, a sachet of cleaning product and a
set of instructions for using these products.
You can order this kit in the same way as the
NESPRESSO capsules.
Warning : In no circumstances should you
use vinegar or descalers intended for
other machines.
Use the following method :
The appliance must be plugged in but
switched off (swtich (c) on «0»). It will be
more effective if the appliance is cold.
• Raise the handle (f1) to open the capsule-
holder head (f) (2 ). Take off the capsule
holder (f3) (8a/8b) and lower the handle (f1)
(2).